Benjamin Moore Ultra Spec HP D.T.M Acrylic Interior/Exterior Paint

  • Ferrous or non-ferrous metal, Bilco doors, railings, structural or support steel, wood, roof decks, equipment, fencing, metal storage shed and general maintenance painting interior or exterior surfaces.
  • Designed to perform a dual purpose as a direct to metal primer and finish
  • Both coats of this product provides rust inhibition for superior corrosion control
  • the film is fast drying permitting fast recoat
  • not for floor application
  • not for exposure to strong chemicals
  • Quart (946 millilitres)- One coat of approximately 80 square feet of surface space
  • Gallon (3.79 litres)- One coat of approximately 320 square feet of surface space
  • *Coverage may vary depending on the surface porosity and texture*

  • The surface to be painted must be clean, dry, and free from oil, grease, dirt, salts, and other contaminants
  • All loose rust or peeling paint should be removed and glossy surfaces should be dulled before recoating
  • If the surface to be painted is water-stained, smoke damaged, grease stained or very slick, use a special purpose primer
  • Consult the technical data sheet or a Merit Decorating associate for specific primer recommendations
  • Use outdoors or in a well-ventilated area
  • Use product when surface temperature is between 10°C (50°F) and 35°C (95°F), and 2.8°C (5°F) above the dew point
  • Stir well before use; apply 2 coats
  • Product can be applied by brush, roller, or spray
  • Thinning: if required use a small amount of clean water. Never add other paints, solvents, or conditioners
  • Keep container closed when not in use
  • Keep out of reach of children
  • It is recommended that anyone who is applying the product or present during application of this product, especially those who are asthmatic, follow the manufacturer's safety precautions
  • It is recommended that pregnant women are not present when product is being applied and drying
  • Dries to touch in 1 hour
  • Can be recoated after 4 hours
  • Humidity and temperature may prolong dry, recoat, and cure times
  • Clean all equipment immediately with soap and warm water. Wash thoroughly after handling
  • Spray equipment should be given a full rinse with mineral spirits to prevent rusting
  • When storing, tightly close container and store upside down
  • Store in a well-ventilated area
  • Do not store near heat, sparks, open flame, or other sources of ignition
  • Protect from freezing
  • In case of spillage, absorb with inert material and dispose of in accordance with local regulations
  • Use completely or dispose of properly
Semi-Gloss                                   Gloss

Safety Data Sheet(FP29-4X)     Safety Data Sheet(FP28-4X)