Krylon Clear Varnish Spray Coating

USE

• Ideal for wood, metal, wicker, glass, plaster, ceramic, and paper-mâché

COVERAGE

• Spray Can (312 grams)- One coat of up to 25 square feet on a solid non-porous surface

SURFACE PREP

• Surface should be clean, dull, and dry
• Remove loose paint, rust, dirt, grease, and oil
• To improve adhesion, sand glossy or rough surfaces until smooth

APPLICATION

• Use outdoors or in a well-ventilated area
• Shake can for 1-2 minutes before use as well as occasionally during use
• Test an inconspicuous area first
• Hold can 10”-12” from surface, spray in sweeping motion from side to side with slight overlap
• Apply multiple thin coats to avoid runs and drips
• For best results, use when air and surface temperature is between 10°C and 29°C (50°F and 85°F) and humidity is below 85%
• Keep out of reach of children
• It is recommended that anyone who is applying the product or present during application of this product, especially those who are asthmatic, follow the manufacturer's safety precautions
• It is recommended that pregnant women are not present when product is being applied and drying

DRYING

• Dries to touch in 15 minutes or less
• Handle after 2 hours
• Once surface is glossy wet, allow 10 minutes before spraying additional coats
• Recoat within 2 hours or after 48 hours

CLEAN UP & STORAGE

• Clean valve by holding can upside down and spraying until only clear gas comes out
• If spray button becomes clogged, wear eye protection, wipe off the button opening with lacquer thinner- DO NOT stick pin in spray button opening
• Clean overspray with paint thinner or lacquer thinner, following solvent manufacturer’s instructions
• Wash hands after using
• For Storage and re-use, clear valve by holding can in an upright position pointed away from you, and push the tip to one side for a few seconds to clear out remaining paint
• Store can inside when not in use
• In extremely cold temperatures, keep can warm
• DO NOT heat on stove, in oven, or in microwave
• Use completely or dispose of properly

SAFETY & TECHNICAL DATA SHEETS