Krylon Appliance Epoxy Spray Paint

USE
  • Ideal for washing machines, refrigerators, dishwashers, freezers, water coolers, and filing cabinets
  • Not for use on stoves, ovens, porcelain, ceramic, or exterior fixtures
  • Ideal for metal  
COVERAGE
  • Spray Can (340 grams)- One coat of up to 20 square feet on a solid non-porous surface
SURFACE PREP
  • Surface should be clean, dull, and dry
  • Remove loose, paint, rust, dirt, grease, and oil
  • To improve adhesion, sand glossy or rough surfaces until smooth
APPLICATION
  • Shake can for 1-2 minutes before use as well as occasionally during use
  • Test an inconspicuous area first
  • Hold can 6”-8” from surface, spray in sweeping motion from side to side with slight overlap
  • Apply multiple thin coats to avoid runs and drips
  • Use outdoors or in a well-ventilated area
  • For best results, use when air and surface temperatures are between 10°C and 29°C (50°F and 85°F) and humidity is below 85%
DRYING
  • Dries to touch in 30 minutes or less
  • Handle after 2 hours
  • Apply additional coats within 2 hours or after 48 hours
CLEAN UP & STORAGE
  • Clean valve by holding can upside down and spraying until only clear gas comes out
  • If spray button becomes clogged, wear eye protection, wipe off the button opening with lacquer thinner-DO Not stick pin in spray button opening
  • Clean overspray with paint thinner or lacquer thinner, following solvent manufacturer’s instructions
  • Wash hands after using
  • For Storage and re-use, clear valve by holding can in an upright position pointed away from you, and push the tip to one side for a few seconds to clear out remaining paint
  • Store can inside when not in use
  • In extremely cold temperatures, keep can warm
  • DO NOT heat on stove, in oven, or in microwave
  • Use completely or dispose of properly
SAFETY & TECHNICAL DATA SHEETS