Benjamin Moore Floor & Patio Latex Interior/Exterior Enamel Paint

USE
  • A quick-drying, epoxy reinforced latex floor enamel with a high gloss finish that is durable and resistant to soaps, detergents, grease, and oil
  • For interior and exterior use on unpainted concrete (new or old) and previously finished wood or concrete, such as basement, sun porch, and breezeway floors
  • Do not apply to bare wood
  • Some tire compositions may stain the floor coatings
COVERAGE
  • Quart (946 millilitres)- One coat of approximately 100 square feet of wall space
  • Gallon (3.79 litres)- One coat of approximately 400 square feet of wall space
  • *Coverage may vary depending on the surface porosity and texture*
SURFACE PREP
  • Surfaces must be thoroughly dry, free of dirt, sealer or waxes, peeling paint, grease or oily substances
  • Glossy surfaces must be dulled by sanding
  • To clean floor, scrub with a detergent and rinse thoroughly with clean water
  • Allow new concrete to cure for 60-90 days
  • New or unpainted concrete surfaces must be etched before application using a concrete etch or a 10% muriatic acid solution; follow manufacturer’s instructions for etching
  • The surface should resemble medium grit sand paper prior to painting
PRIMING
  • Self-priming on properly prepared concrete surfaces
  • A separate primer can be used when there is a significant colour change, new drywall, or painting over oil paint
  • Ask about special purpose primers such as for wood substrates
APPLICATION
  • Use outdoors or in a well-ventilated area
  • Stir thoroughly before and occasionally during use
  • One coat is usually sufficient for repaint work; 2 coats for new work
  • Do not paint when temperature of air and surface is below 10°C (50°F) or above 32°C (90°F)
  • Do not thin
  • Product can be applied by brush, roller, or spray
  • CAUTION: all floor coatings may become slippery when wet
  • Where non-skid characteristics are desired, a small amount of clean sand may be added
  • Keep container closed when not in use
  • Keep out of reach of children
  • It is recommended that anyone who is applying the product or present during application of this product, especially those who are asthmatic, follow the manufacturer's safety precautions
  • It is recommended that pregnant women are not present when product is being applied and drying
DRYING
  • Dries to touch in 1 hour
  • Can be recoated overnight under good drying conditions (adequate ventilation, air circulation and lack of excessive humidity)
  • Withstands light traffic after overnight dry
  • Humidity and temperature may prolong dry, recoat, and cure times
CLEAN UP & STORAGE
  • Clean equipment immediately after use with soap and warm water
  • Spray equipment should be given a final rinse with mineral spirits to prevent corrosion
  • In case of spillage, absorb with inert material and dispose of in accordance with local regulations
  • Wash thoroughly after handling
  • This product contains components which may cause adverse effects to the environment if handled improperly
  • When storing, tightly close container and store upside down
  • Store in a well-ventilated area
  • Do not store near heat, sparks, open flame, or other sources of ignition
  • Protect from freezing
  • Use completely or dispose of properly
SAFETY & TECHNICAL DATA SHEETS
Low Sheen                                              High Gloss

Safety Data Sheet-Base 4 (F122-4X)     Safety Data Sheet-Base 4 (K121-4X)