INSL-X Seal Lock Plus Interior Primer (IL-6800)

USE

• Primes, seals, and blocks stains on plaster, drywall, wood, metal, and masonry
• Use a sealer for “hot plaster”, multi-colour finishes and a stain blocker for creosote, asphalt, aniline, tanning bleeding, crayon, ink, redwood. Grease, and knots
• Use a vapour barrier (perm rating of 0.3)
• Not for use in immersion surfaces
• Do not use a top coat containing aromatic hydrocarbons or oxygenated solvents
• Can be used for exterior spot priming

COVERAGE

• Quart (946 millilitres)- One coat of approximately 100 square feet of wall space
• Gallon (3.79 litres)- One coat of approximately 400 square feet of wall space

• *Coverage may vary depending on the surface porosity and texture*

SURFACE PREP

• SEE PRODUCT DATA SHEET FOR COMPLETE PREPARATION AND APPLICATION INSTRUCTIONS
• Remove grease, dirt, oil, wax, scaling paint, wallpaper paste, and other foreign matter by solvent or detergent cleaning
• Rinse with clean water and allow to dry thoroughly
• Remove mildew with a commercial mildewcide
• Dull glossy surfaces by sanding
• Fill cracks and nail holes with patching compound, sand smooth and remove dust

APPLICATION

• Use in a well-ventilated area
  
• Stir thoroughly before and during use; 1 coat is usually enough but sometimes a second coat is needed
• Apply directly from the container
• Product can be applied by brush, roller, or spray
• Apply when material, substrate, and ambient temperatures are between 4.4°C (40°F) and 32.2°C (90°F)
• May be tinted with up to 60 mL (2 oz) per 3.79L of universal colourant
• DO NOT THIN
• Keep container closed when not in use
• Keep out of reach of children
• It is recommended that anyone who is applying the product or present during application of this product, especially those who are asthmatic, follow the manufacturer's safety precautions
• It is recommended that pregnant women are not present when product is being applied and drying

DRYING

• Tack free in 15 minutes
• For multiple-coat application, allow a 2-hour dry time between coats
• Humidity and temperature may prolong dry, recoat, and cure times

CLEAN UP & STORAGE

• Clean equipment with denatured alcohol promptly after use
• In case of spillage, absorb with inert material and dispose of in accordance with local regulations
• Wash thoroughly after handling
  
• When storing, tightly close container and store upside down
• Store in a well-ventilated area
• Do not store near heat, sparks, open flame, or other sources of ignition
• Protect from freezing
  
• Use completely or dispose of properly

SAFETY & TECHNICAL DATA SHEETS

Safety Data Sheet (IL-6800)

Technical Data Sheet (IL-6800)