INSL-X STIX Waterborne Bonding Interior/Exterior Primer (SXA-110)

USE

• For priming challenging, interior or exterior surfaces, including PVC, vinyl, plastic, glass, tile, glazed block, glossy paints, pre-coated siding, fibreglass, galvanized metals
• It is also ideal for plaster, drywall, and wood substrates in commercial, institutional, and residential applications
• Do not use below grade or where continuous water contact is common
• Do not use over polyethylene, polypropylene, or Kynar
• Use only as a spot primer on exterior wood

COVERAGE

• Quart (946 millilitres)- One coat of approximately 100 square feet of wall space
• Gallon (3.79 litres)- One coat of approximately 400 square feet of wall space

• *Coverage may vary depending on the surface porosity and texture*

SURFACE PREP

• SEE PRODUCT DATA SHEET FOR COMPLETE PREPARATION AND APPLICATION INSTRUCTIONS
• Wash surface with a strong detergent and stiff brush or by power washing. Rinse and allow to dry
• Use lacquer thinner or xylene to remove grease and oil
• Reduce the gloss by sanding and remove dust
• Seal wood knots with pure shellac prior to applying full coat of primer
• Remove old caulk before priming and re-caulk edges and paint breaks after priming
• Remove mildew
• Prime ferrous metals with a rust inhibitive primer prior to application of this primer

APPLICATION

• Use in a well-ventilated area
  
• Product can be applied by nylon/polyester brush, synthetic roller cover, pad applicator, or airless spray
• Top coat required for exterior durability
• For questionable substrates, try a small area for adhesion
• Try a test area for top coat compatibility
• Apply when air, surface, and product temperature are above 1.7°C (35°F)
• Do not apply in direct sunlight or on a hot surface
• Avoid rain, moisture, or high humidity for the first 24 hours of curing
• DO NOT THIN
• Keep container closed when not in use
• Keep out of reach of children
• It is recommended that anyone who is applying the product or present during application of this product, especially those who are asthmatic, follow the manufacturer's safety precautions
• It is recommended that pregnant women are not present when product is being applied and drying
  

DRYING

• Tack free in 30 minutes
• For multiple-coat application, allow a 3-4-hour dry time between coats
• Top coat with two component paint will be dry in 24 hours
• Fully cures in 7-10 days
• Humidity and temperature may prolong dry, recoat, and cure times

CLEAN UP & STORAGE

• Clean brushes, rollers, and other equipment with warm, soapy water immediately after use. If dry, clean with lacquer thinner
• In case of spillage, absorb with inert material and dispose of in accordance with local regulations
• Wash thoroughly after handling
  
• When storing, tightly close container and store upside down
• Store in a well-ventilated area
• Do not store near heat, sparks, open flame, or other sources of ignition
• Protect from freezing
  
• Use completely or dispose of properly

SAFETY & TECHNICAL DATA SHEETS

Safety Data Sheet (SXA-110)

Technical Data Sheet (SXA-110)