Benjamin Moore ADVANCE Interior Paint

USE

• A premium quality, inter waterborne alkyd enamel coating that dries to a smooth, hard finish.
• Advance provides a finish that is equal to the best solvent-thinned alkyd finishes.
• Recommended for properly primed interior surfaces of wood, cured plaster, wallboard, metal, and masonry.
• Ideal for new and previously painted interior trim, doors, walls, ceilings, and furniture

COVERAGE

• Quart (946 millilitres)- One coat of approximately 100 square feet of wall space
• Gallon (3.79 litres)- One coat of approximately 400 square feet of wall space
• *Coverage may vary depending on the surface porosity and texture*

SURFACE PREP

• Surfaces must be clean, dry, and free of grease, wax, dust, mildew, rust, and loose and scaling paint.
• Glossy surfaces should be dulled
• New plaster and masonry must be thoroughly cured before priming

PRIMING

• Advance can be applied over an oil or latex primer
• Ask about special purpose primers for wood, drywall substrates, plaster, masonry, and metal surfaces or if the surface to be painted is stained, smoke damaged, or very slick
• Certain deep custom colours may require a deep base primer

APPLICATION

• Use in a well-ventilated area
• Do not apply when air and surface temperatures are below 10°C (50°F)
• Stir thoroughly before and during use; Apply 2 coats
• This product can be applied by brush, roller, and spray
• Keep container closed when not in use
• Keep out of reach of children
• It is recommended that anyone who is applying the product or present during application of this product, especially those who are asthmatic, follow the manufacturer's safety precautions
• It is recommended that pregnant women are not present when product is being applied and drying
  

DRYING

• Dries to touch in 4-6 hours; allow 16 hours to dry before sanding and applying second coat
• Advance’s full hardness and adhesion develops over time
• Do not expose to heavy abrasion or return shelves/table tops to service for at least 3-5 days to prevent damage to the finish
• Humidity and temperature may prolong dry, recoat, and cure times

CLEAN UP & STORAGE

• Clean up with soap and warm water; wash thoroughly after handling
  
• Brushes and rollers should be given a final rinse with mineral spirits to remove residual alkyd
• Spray equipment should be given a final rinse with mineral spirits to prevent rusting
• In case of spillage, absorb with inert material and dispose of in accordance with local regulations
  
• When storing, tightly close container and store upside down
• Store in a well-ventilated area
• Do not store near heat, sparks, open flame, or other sources of ignition
• Protect from freezing
  
• Use completely or dispose of properly

SAFETY & TECHNICAL DATA SHEETS

Safety Data Sheet-Base 4 (K792-4X)     Safety Data Sheet-Base 1 (K793-4X)     Safety Data Sheet-Base 1 (F794-4X)