Benjamin Moore Floor & Patio Latex Interior/Exterior Enamel Paint

USE

• A quick-drying, epoxy reinforced latex floor enamel with a high gloss finish that is durable and resistant to soaps, detergents, grease, and oil
• For interior and exterior use on unpainted concrete (new or old) and previously finished wood or concrete, such as basement, sun porch, and breezeway floors
• Do not apply to bare wood
• Some tire compositions may stain the floor coatings

COVERAGE

• Quart (946 millilitres)- One coat of approximately 100 square feet of wall space
• Gallon (3.79 litres)- One coat of approximately 400 square feet of wall space
• *Coverage may vary depending on the surface porosity and texture*

SURFACE PREP

• Surfaces must be thoroughly dry, free of dirt, sealer or waxes, peeling paint, grease or oily substances
• Glossy surfaces must be dulled by sanding
• To clean floor, scrub with a detergent and rinse thoroughly with clean water
• Allow new concrete to cure for 60-90 days
• New or unpainted concrete surfaces must be etched before application using a concrete etch or a 10% muriatic acid solution; follow manufacturer’s instructions for etching
• The surface should resemble medium grit sand paper prior to painting

PRIMING

• Self-priming on properly prepared concrete surfaces
• A separate primer can be used when there is a significant colour change, new drywall, or painting over oil paint
• Ask about special purpose primers such as for wood substrates

APPLICATION

• Use outdoors or in a well-ventilated area
  
• Stir thoroughly before and occasionally during use
• One coat is usually sufficient for repaint work; 2 coats for new work
• Do not paint when temperature of air and surface is below 10°C (50°F) or above 32°C (90°F)
• Do not thin
• Product can be applied by brush, roller, or spray
• CAUTION: all floor coatings may become slippery when wet
• Where non-skid characteristics are desired, a small amount of clean sand may be added
• Keep container closed when not in use
• Keep out of reach of children
• It is recommended that anyone who is applying the product or present during application of this product, especially those who are asthmatic, follow the manufacturer's safety precautions
• It is recommended that pregnant women are not present when product is being applied and drying
  

DRYING

• Dries to touch in 1 hour
• Can be recoated overnight under good drying conditions (adequate ventilation, air circulation and lack of excessive humidity)
• Withstands light traffic after overnight dry
• Humidity and temperature may prolong dry, recoat, and cure times

CLEAN UP & STORAGE

• Clean equipment immediately after use with soap and warm water
• Spray equipment should be given a final rinse with mineral spirits to prevent corrosion
• In case of spillage, absorb with inert material and dispose of in accordance with local regulations
• Wash thoroughly after handling
  
• This product contains components which may cause adverse effects to the environment if handled improperly
• When storing, tightly close container and store upside down
• Store in a well-ventilated area
• Do not store near heat, sparks, open flame, or other sources of ignition
• Protect from freezing
  
• Use completely or dispose of properly

SAFETY & TECHNICAL DATA SHEETS

Safety Data Sheet-Base 4 (F122-4X)     Safety Data Sheet-Base 4 (K121-4X)