Krylon Appliance Epoxy Spray Paint

USE

• Ideal for washing machines, refrigerators, dishwashers, freezers, water coolers, and filing cabinets
• Not for use on stoves, ovens, porcelain, ceramic, or exterior fixtures
• Ideal for metal  

COVERAGE

• Spray Can (340 grams)- One coat of up to 20 square feet on a solid non-porous surface

SURFACE PREP

• Surface should be clean, dull, and dry
• Remove loose, paint, rust, dirt, grease, and oil
• To improve adhesion, sand glossy or rough surfaces until smooth

APPLICATION

• Shake can for 1-2 minutes before use as well as occasionally during use
• Test an inconspicuous area first
• Hold can 6”-8” from surface, spray in sweeping motion from side to side with slight overlap
• Apply multiple thin coats to avoid runs and drips
• Use outdoors or in a well-ventilated area
• For best results, use when air and surface temperatures are between 10°C and 29°C (50°F and 85°F) and humidity is below 85%

DRYING

• Dries to touch in 30 minutes or less
• Handle after 2 hours
• Apply additional coats within 2 hours or after 48 hours

CLEAN UP & STORAGE

• Clean valve by holding can upside down and spraying until only clear gas comes out
• If spray button becomes clogged, wear eye protection, wipe off the button opening with lacquer thinner-DO Not stick pin in spray button opening
• Clean overspray with paint thinner or lacquer thinner, following solvent manufacturer’s instructions
• Wash hands after using
• For Storage and re-use, clear valve by holding can in an upright position pointed away from you, and push the tip to one side for a few seconds to clear out remaining paint
• Store can inside when not in use
• In extremely cold temperatures, keep can warm
• DO NOT heat on stove, in oven, or in microwave
• Use completely or dispose of properly

SAFETY & TECHNICAL DATA SHEETS