INSL-X Cabinet Coat Urethane-Acrylic Satin Interior Enamel Paint

USE

• For new or dingy painted, polyurethaned, or varnished cabinets and shelving, wood trim, furniture, woodwork, doors, and other interior surfaces
• Not for immersion service or for the surfaces of stoves or ovens

COVERAGE

• Quart (946 millilitres)- One coat of approximately 100 square feet of wall space
• Gallon (3.79 litres)- One coat of approximately 400 square feet of surface space

• *Coverage may vary depending on the surface porosity and texture*

SURFACE PREP

• Surface must be clean, dry, firm, free of dirt, wax, and grease
• Use a strong detergent solution and clean vigorously
• Remove wax
• Sand, scrape, or wire brush (metal) to remove peeling paint
• Remove mildew
• SEE PRODUCT DATA SHEET FOR COMPLETE INSTRUCTIONS

PRIMING

• Previously painted or varnishes surfaces: self priming on surface in good condition. Spot prime bare spots with Cabinet Coat and allow to dry overnight
• new wood: sand the surface. Self priming. Allow first coat to dry overnight. Sand between coats with fine sandpaper
• ferrous metal: prime bare spots with metal primer
• melamine or Formica: self priming. Sand with fine sandpaper

APPLICATION

• Use in a well-ventilated area
  
• Stir thoroughly
• Apply with a synthetic bristle brush, short nap roller (3/8” or less) or HVLP spray
• Keep a wet edge
• Two thin coats are better than one heavy coat
• DO NOT THIN
• Do not apply when surface or air temperature is below 12.8°C (55°F) and above 32.2°C (90°F)
• Keep container closed when not in use
• Keep out of reach of children
• It is recommended that anyone who is applying the product or present during application of this product, especially those who are asthmatic, follow the manufacturer's safety precautions
• It is recommended that pregnant women are not present when product is being applied and drying
  

DRYING

• At 25°C (77°F):
  • tack free in 1 hour
  • recoat after 6 hours
  • bare wood: 1^st cost dries after 16 hours
  • ready to put into use after 12-24 hours
• Humidity and temperature may prolong dry, recoat, and cure times

CLEAN UP & STORAGE

• Clean up with soap and warm water immediately after use; wash thoroughly
• In case of spillage, absorb with inert material and dispose of in accordance with local regulations
  
• When storing, tightly close container and store upside down
• Store in a well-ventilated area
• Do not store near heat, sparks, open flame, or other sources of ignition
• Protect from freezing
  
• Use completely or dispose of properly

SAFETY & TECHNICAL DATA SHEETS

Safety Data Sheet-Base 4 (CC-554B)

Technical Data Sheet (CC-55XX)