Lenmar Waterborne Interior Wiping Wood Stain (1WB.1300)

USE
  • Interior wood furniture, panelling, cabinets, trim, doors, and floors
  • If used on wood floors it must be top-coated with a clear floor finish
COVERAGE
  • Pint (458 millilitres)- One coat of approximately 50 square feet of surface space
  • Quart (946 millilitres)- One coat of approximately 100 square feet of surface space
  • Gallon (3.79 Litres)- One coat of approximately 400 square feet of surface space
  • *Coverage may vary depending on the surface porosity and texture*

SURFACE PREP
  • Wood should be clean, dry, and free of dust, wax, and grease
  • Sand wood along the grain with 120 or 150 grit sandpaper and remove dust with tack rags or a vacuum cleaner
  • Previously finished surfaces must be cleaned down to bare wood
  • Do not use steel wool as this may result in rust staining
APPLICATION
  • Use in a well-ventilated area
  • Test colour by staining and finishing a sample piece of the wood
  • The appearance of the stain and clear finish will vary depending on the type of wood and its natural colour, texture, and grain porosity
  • On softwoods such as pine, an un-tinted coat of Interior Waterborne Wiping Wood Stain base may be applied as a conditioner prior to staining to equalize absorption and produce a more uniform colour
  • Apply the un-tinted stain base liberally and allow to soak into the wood for 3-5 minutes; wipe off the excess, and stain immediately
  • Ensure colour uniformity by stirring contents thoroughly before and occasionally during use
  • If more than one container is required for the job, intermix (box) them to avoid possible colour differences
  • Apply stain liberally and allow to absorb as required to achieve the desired depth of colour and then wipe the surface with a clean lint free cloth in the direction of the grain to remove excess stain
  • Do not allow the stain to dry on the surface before wiping
  • Depending on temperature and humidity, the stain will remain workable for 5-10 minutes; use care to maintain a wert edge to prevent lapping
  • If lapping does occur, it can often be blended away by saturating the surface with fresh stain and re-wiping
  • Do no apply when surface and air temperatures are below 10°C (50°F)
  • May be top-coated with either a water based or solvent based finish after 3-4 hours dry time
  • Keep container closed when not in use
  • Keep out of reach of children
  • It is recommended that anyone who is applying the product or present during application of this product, especially those who are asthmatic, follow the manufacturer's safety precautions
  • It is recommended that pregnant women are not present when product is being applied and drying
DRYING
  • Sets to touch in 30 minutes
  • Can be top coated after 3-4 hours
  • Humidity and temperature may prolong dry, recoat, and cure times
CLEAN UP & STORAGE
  • Use soap and warm water; wash thoroughly after handling
  • In case of spillage, absorb with inert material and dispose of in accordance with local regulations
  • When storing, tightly close container and store upside down
  • Store in a well-ventilated area
  • Do not store near heat, sparks, open flame, or other sources of ignition
  • Protect from freezing
  • Use completely or dispose of properly
SAFETY & TECHNICAL DATA SHEETS

Safety Data Sheet (1WB.1300)

Technical Data Sheet (1WB.1300)