Benjamin Moore Notable Dry Erase White Paint (K500-01)

MEASURE (1)

• Measure the areas to be painted (height x width = square metres [footage]) to ensure you will have enough paint
• Do not stretch paint beyond indicated surface area shown on your kit as each kit is formulated for the specified recommended coverage

PREP (2)

• Prepare your area by repairing any cracks, holes, or breaks and clean away any dirt or dust
• Next, level any dried spackling by lightly sanding the patches as well as any other rough spots so it blends in with the surface
• Frame the area to be primed with painters’ tape
• Use at least 10 cm of tape at the bottom to help capture any drips
• Make sure the tape is sealed smoothly without wrinkles
• This product works best when your surface is smooth to the touch

PRIME (3)

• Prime the following areas if needed, and let dry for 24 hours:
  • Any areas where filler/spackle/compound was used
  • When painting over a flat or matte finish
  • If painting over new dry wall
  • If painting over a different surface colour
• We recommend priming with Benjamin Moore Fresh Start Multi-Purpose Latex Primer
• Once primed, use a non-flat intermediate white base coat

MIX (4)

• If needed, use pliers to remove safety ring or clips from Part A
• Put on gloves, then pour Part B into Part A and hand stir thoroughly for 2 minutes- do not drill mix or shake
• There is no indication time and notable can be applied immediately, but must be applied within 4 hours of mixing
• Do not use a plastic tray liner for rolling

APPLY (5)

• Use in a well-ventilated area
  
• Before applying, clean the area of any loose dirt or debris
• Be sure to open a window or use a fan to ensure proper airflow and ventilation
• Product may be applied by brush to cut in the edges, if desired
• For rolling, use the roller cover provided in your kit and do not overload the roller
• The product should be applied 4.6 square metres (50 square feet) at a time (approximately in 1.5 m sections
• Start at the top left corner of your section and apply using up and down strokes
• Use minimal pressure to avoid drips
• Wait 5-10 minutes and then apply a second coat on the wet film
• Any wet areas that need to be touched up must be done within 30 minutes
• Keep container closed when not in use
• Keep out of reach of children
• It is recommended that anyone who is applying the product or present during application of this product, especially those who are asthmatic, follow the manufacturer's safety precautions
• It is recommended that pregnant women are not present when product is being applied and drying
  

WAIT (6)

• Wait 30 minutes to remove painters’ tape and pull off at a 45-degree angle
• Product will e dry to touch in 4 hours, but has a full cure time of 7 days

READY TO USE (7)

• After 7-day cure period, it is safe to use any standard dry erase marker on the new surface (Expo markers are recommended)
• Remove marks with any standard dry eraser
• For harder to erase marks, we recommend using Expo cleaner
• For best results, do not leave standard dry erase marks on a dry erase surface for more than 30 days
• Clean-up using mineral spirits
• In case of spillage, absorb with inert material and dispose of in accordance with local regulations
• Wash thoroughly after handling
  
• To recoat after it has cured, lightly sand and follow steps 3-7
• When storing, tightly close container and store upside down
• Store in a well-ventilated area
• Do not store near heat, sparks, open flame, or other sources of ignition
• Protect from freezing
  
• use completely or dispose of properly

SAFETY & TECHNICAL DATA SHEETS

Safety Data Sheet-Catalyst (K500-90)

Technical Data Sheet-White Paint (K500)